Hallberg Rassy Rasmus 35

Hallberg Rassy Rasmus 35
An Old Classic

Friday, September 23, 2011

Custom Hardtop/Dodger

Hello Rasmus Owners,

I am in the process of designing and building hardtop/dodger and I am trying to get as close to the factory dimensions as possible.  If any merciful soul out there has a Hallberg Rassy factory built hardtop  I would love to get a couple of measurements off of you.

1. The length from the center and bottom of the forward windshield (where the dodger sits on the dodger step) to the bottom of the hardtop roof (following the angle of the windshield).

2.  The length from the bottom  (where the dodger sits on the dodger step) of the corner where the front windshield ajoins the diagonal windshield to the bottom of the hardtop roof (following along the intersection of the front and diagonal windshields).

3. The length from the bottom  (where the dodger sits on the dodger step) of the corner where the diagonal windshield ajoins the side windshield to the bottom of the hardtop roof (following along the intersection of the diagonal and side windshields).

4. The length from the bottom of the side windshield (where the dodger sits on the dodger step) following the stearn end of the harddodger to the bottom of the hardtop roof (following the angle of the windshield).

The measurements don't have to be supremely accurate.  To the nearest quarter inch would be fine.  I just need a rough guideline. Well, not too rough.  Thanks to anyone that can lend me a hand on this project.  I will post the work at http://www.lizardheadone.com/

2 comments:

Cabatach said...

Pat

If you're not in a hurry i can help. Boat is laid up for winter again and I'm not going back up there till end of November.

Mine is an original hardtop

I could take photos and overlay dimensions for you if you want.

Euan

Pat Sixbey said...

If you can get dimensions outlined above I would really appreciate it. Late November may not be too late. I will let you know if I proceed without them. Thanks Euan.
Pat